Boonton 4540 Peak Power Meter Quick Start Manuel d'utilisateur télécharger pdf (Page 31)

4540 Power Meter

Quick Start Guide

Pulse Mode is only available when using a peak power sensor, and is best choice

for most pulse modulated and periodic signals. Multiple modulation cycles may be

averaged together, and measurement intervals may span both before and after the

trigger. Pulse Mode is best for the following types of measurements:

• Moderate signal level (above about -40dBm except when modulation is

“off”).

• The signal is periodic.

• A time snapshot of a single event is needed (minimum single-shot time

is 200 nano seconds).

• Typical modulation and signal types: NADC, GSM (and extensions),

TDMA, RADAR, SatCom, TCAS, Bluetooth, iDEN, NTSC, Wireless

LAN.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Pas de commentaire

Boonton 4540 Peak Power Meter Quick Start Manuel d'utilisateur Page 31