Boonton 52000 Series USB CW Power Sensor Manuel d'utilisateur télécharger pdf (Page 26)

26 Using the Software

When the software is started, measurement results are displayed

right away. However you are reminded that you should zero the

sensor. Zero your sensor On the right side of the user interface you

are reminded that the sensor is not zeroed. For more information on

zeroing your sensor, refer to “What is zeroing?” on page 56. Use the

following procedure to zero your measurement sensor:

Making a measurement

The following procedure outlines a typical measurement procedure.

Do this Comment

1. With the sensor still connected, select the zero icon .

Or select Measurement > Zero Sensor

2. Conrm you wish to zero the sensor, select OK.

Ensure no power is being applied to the sensor during this process.

3. Wait until the zeroing is completed.

When the zero process is complete, the reminder is removed from the

user interface.

Do this Comment

1. Zero the sensor.

Refer to “Zero your sensor” on page 26.

2. Open the measurement control panel. Select the control panel icon

or select Measurement > ControlPanel.

Refer to Figure 19 on page 27.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 67 68

Pas de commentaire

Boonton 52000 Series USB CW Power Sensor Manuel d'utilisateur Page 26