Boonton PIM 31 User Manual Manuel d'utilisateur télécharger pdf (Page 58)

7.4.3 Sweep Mode

IM products in linear environment are frequency independent. Many passive

components show a frequency response that is less linear or strongly frequency

dependent. The sweep mode increments / decrements carrier signals by 1 MHz.

covering a Tx range that results in a sweep of the complete Rx frequency range.

Any deviations of PIM measurements that are frequency dependent are

immediately visible.

Element

Name

Description / Display

Pull-Down menu

Allows Screenshots, data logging, and self test. For

more information refer to chapter “Pull-Down

menus”.

Carrier display

Carrier signal information: Frequencies, Power

levels

Graphical display

Shows two traces (red / yellow) of an IM product

that are generated by

a) sweeping the lowest frequency upwards – red

trace and after that

b) sweeping highest frequency carrier signal

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 109 110

Pas de commentaire

Boonton PIM 31 User Manual Manuel d'utilisateur Page 58